Trautwein® Water Bath Basic 66

The water bath is an alternative to traditional fango preparation devices. This preparation device is used exclusively in medical facilities and physical therapy practices.

The fango kitchen in physiotherapy can be designed in various ways. In addition to established devices such as hot air ovens or fango mixers, there is the alternative of using a water bath. Compared to the fango mixer and the warming cabinet, the water bath can score with a positive energy balance. The handling of mud packs and heat carriers is somewhat simplified and more cost-effective. In addition, using the water bath also results in time savings for you and your staff.

For the storage of the heat carriers, a bottom insert with spacers is included. The number of heat carriers is based on the package dimensions: 30x40 cm.

- Capacity: 24 heat carriers 30x40 cm
- Interior volume: 68 l
- Power: 1550 watts, operating voltage 230 V, 50 Hz
- Interior dimensions: (WxHxD) 63x21x51 cm
- Exterior dimensions: (WxHxD) 75x31x66 cm
- Lid with handlebar and 2 hinges
- Energy-saving insulation against heat loss
- Operating indicator light
- Temperature can be regulated in the range of 30° - 110° degrees
- Drain tap for water drainage
- Device connection cable with plug, 1.8 m long

The water bath is a stainless steel container with a heating mat. The water is filled into the container and heated to approximately 60 °C within 2 hours. After that, you should insert the reusable heat carriers filled with peat. The heat carriers take about 45 minutes to reach their operating temperature. After that, you can use the peat heat carriers for mud pack treatments.